Color fill

[RobC]

I’ve run across a peculiar issue with color fill. When I create a shape, either with freehand or other mode, and then click to fill it with a color, sometimes the color does not stay contained within the shape. I’ve experimented with this, and found that any line width of 4 pixels or less will not contain the color. When looked at, the line(s) are porous, so the color leaks out of the shape. Has anyone else run across this issue? Is there a fix, or just a glitch in the program?

[-fjg-]

The fill tool remembers the last tolerance setting, so it may be set too high.

You can lower the tolerance by dragging to the left after clicking to fill an area. If you run out of screen space to drag, you can pick up the stylus and drag multiple times (in the same fill area) if you can't get tolerance low enough the first time.

Using a single pixel brush here and the fill tool works fine with low tolerance.

[RobC]

Thank you SO MUCH for that tip!