Lucky Clan Forum

Support => Suggestions, Ideas, Bugs => Topic started by: Husketch on May 06, 2018, 03:02:28 AM

Title: Make Elastify Deformation Smoother
Post by: Husketch on May 06, 2018, 03:02:28 AM

Hello!
I love that ASP has Elasify filter now, that's so useful and works well.
However, I noticed it's hard to get smoother deformation even on low Strength levels.

Often the case: the deformation creates a lot of sharp points and edges, instead of smoother ,relaxed deformation.

The grid(mesh) deforms a bit harsh and it's not easy to smoothen after those sharp edges/ points are created.

Can you please improve the smoothness of the Elastify filter?
 I tested the same settings in PS and it doesn't have those harsh sharp corners when you deform, but more smooth curves.

Thanks for looking into it!

Title: Re: Make Elastify Deformation Smoother
Post by: Lucky Clan on May 06, 2018, 03:25:28 AM

Use Smooth mode, this exactly for that.

Title: Re: Make Elastify Deformation Smoother
Post by: Husketch on May 06, 2018, 03:37:49 AM

Quote from: Lucky Clan on May 06, 2018, 03:25:28 AM

Use Smooth mode, this exactly for that.

Wow yes smooth mode solves the issue! Thanks:)
I would still prefer if Smudge mode work a little bit smoother than this.. so you don't have to switch modes very often. But I'm glad I discovered the smooth mode now. Thanks very much :)

Title: Re: Make Elastify Deformation Smoother
Post by: Husketch on July 19, 2018, 06:02:31 AM

After using Elastify for a while, I still think the effect can be a little bit smoother softer please.
So I don't have to always switch to Smooth mode.

I think the effect of the smudge can have a little bit more softness to it. (Softer edges to the brush) so it doesn't create a lot of sharp corners.

And maybe in the future the softness (blurred edges) value can be adjusted :)

Cheers!